Type spectrum 01.04
2-4 SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
The optional boards listed below, along with various others, have not been officially
released and may only be used in consultation with the appropriate SIEMENS department:
Options Codes Order No.
SBP Pulse encoder evaluation board
1) 2)
5)
(miniature-format board; LBA + ADB required)
6SX7010-0FA00
SLB SIMOLINK board
1) 5)
(miniature-format board; LBA + ADB required)
6SX7010-0FJ00
CBC Communications board with interface for CAN protocol
1) 5)
(miniature-format board; LBA + ADB required)
6SX7010-0FG00
1) The EB1, EB2 and CBP2 boards can be ordered under two different numbers, i.e.
• under the order number of the board without accessories (such as connectors and Short Guide) as a
spare part
• as a retrofit kit: board with connectors and Short Guide when the board is ordered as an option
Board Order number of board (w/o
accessories)
Order number of retrofit kit
EB1 6SE7090-0XX84-0KB0 6SX7010-0KB00
EB2 6SE7090-0XX84-0KC0 6SX7010-0KC00
CBP2 6SE7090-0XX84-0FF5 6SX7010-0FF05
The retrofit kit must be ordered to install boards in the SIMOTRAS HD converter so that the correct
connectors for system cabling and the Short Guide are also available.
The LBA local bus adapter and ADB adapter board must be ordered as additional components for
installing supplementary boards in the SIMOTRAS HD converter. These adapters are available under
separate order numbers.
2) A pulse encoder evaluation circuit is a standard component of the basic SIMOTRAS HD converter. The
SBP need therefore be ordered only in configurations requiring evaluation of a second pulse encoder.
3) An LBA local bus adapter is required to install this board in a SIMOTRAS HD converter. The adapter is
available under a separate order number.
4) This board may only be used in consultation with the appropriate SIEMENS department.
5) LBA and ADB are available under separate order numbers
To Next Page
Loading...
