Connectors and binectors 01.04
12-24 SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
12.2 Binector list
The states of binectors can be displayed via parameters r045 and P046.
Binector Name, description Function
diag., Sheet
Fixed values
B0000
Fixed value 0 G120
B0001
Fixed value 1 G120
Binary inputs, terminals 36 to 43
B0010
Status of terminal 36 G110
B0011
Status of terminal 36, inverted G110
B0012
Status of terminal 37 G110
B0013
Status of terminal 37, inverted G110
B0014
Status of terminal 38 G110
B0015
Status of terminal 38, inverted G110
B0016
Status of terminal 39 G110
B0017
Status of terminal 39, inverted G110
B0018
Status of terminal 40 G110
B0019
Status of terminal 40, inverted G110
B0020
Status of terminal 41 G110
B0021
Status of terminal 41, inverted G110
B0022
Status of terminal 42 G110
B0023
Status of terminal 42, inverted G110
B0024
Status of terminal 43 G110
B0025
Status of terminal 43, inverted G110
Binary inputs, terminals 211 to 214
B0040
Status of terminal 211 G186
B0041
Status of terminal 211, inverted G186
B0042
Status of terminal 212 G186
B0043
Status of terminal 212, inverted G186
B0044
Status of terminal 213 G186
B0045
Status of terminal 213, inverted G186
B0046
Status of terminal 214 G186
B0047
Status of terminal 214, inverted G186
Analog inputs
B0050
Analog input, terminal 4: 1 = Open circuit (i ≤ 2 mA)
G113
B0051
Analog input, terminal 6: 1 = Open circuit (i ≤ 2 mA)
G113
Pulse encoder evaluation
B0052
Fault in digital speed sensing circuit G145
B0053
Underflow of actual position value [SW 1.9 and later]
This binector changes to 1 when connector KK0046 (actual position value extended in software to a 32-bit
value) counts from value 8000 0000H (= –2
31
) to value 7FFF FFFFH (= +2
31
–1).
Binector B0053 does not change back to 0 until connector KK0046 assumes a value other than 7FFF
FFFFH (= +2
31
–1) again.
G145
B0054
Overrflow of actual position value [SW 1.9 and later]
This binector changes to 1 when connector KK0046 (actual position value extended in software to a 32-bit
value) counts from value 7FFF FFFFH (= +2
31
–1) to value 8000 0000H (= –2
31
).
Binector B0054 does not change back to 0 until connector KK0046 assumes a value other than 8000
0000H (= –2
31
) again.
G145
To Next Page
Loading...
