Siemens SIMOTRAS 6SG7050 - Mounting Options; Terminal Expansion Board CUD2

Installation 01.04
5-8 SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
5.2 Mounting options
5.2.1 Terminal expansion board CUD2
a
a
s
s
d
d
s
• Remove electronics board CUD1 from the electronics box by undoing the two fixing screws
a.
• Attach the 3 supplied hexagon-head studs at position
s on the CUD1 electronics board.
• Position board CUD2 in such a way that the two plug connectors
d are properly contacted.
The two plug connectors must be positioned such that the short pin ends are inserted in the
socket connectors of the CUD1 and the long pin ends in the socket connectors of the CUD2.
• Secure board CUD2 in position using the supplied screws and retaining elements
s.
• Insert electronics board CUD1 into electronics box and tighten up the two fixing screws
a again
as instructed.