Installation 01.04
5-2 SIEMENS AG 6SG7000-0BA76
SIMOTRAS HD Operating Instructions
Cubicle mounting of D400 / 900 Mre converters
as
• These converters are supplied with 2 fixing angles
a. These can be bolted to the
SIMOTRAS HD unit by means of the supplied M6 hexagon-head screws (3 per angle) to assist
cubicle mounting.
• The unit can then be supported by 2 further angles
s (not included in scope of supply) in the
control cubicle.
• The converters must be bolted to the cubicle rear panel in 4 places.
5.1 Dimension drawings
WARNING
A clearance of at least 100 mm must be left above and below the converter in order to ensure
an unrestricted cooling air intake and outlet.
The converter may overheat if this clearance is not provided!
To Next Page
Loading...
