General 01.04
© Siemens AG 1999 - 2004 All rights reserved
These Operating Instructions are available in the following languages:
Language German
Order No.: 6SG7000-0BA00
Converter software version:
As these Operating Instructions went to print, SIMOTRAS HD converters were being delivered from the
factory with software version 2.1 installed.
These Operating Instructions also apply to other software versions.
Earlier software versions: Some parameters described in this document might not be stored in the software
(i.e. the corresponding functionality is not available on the converter) or some
parameters will have a restricted setting range. If this is the case, however,
appropriate reference to this status will be made in the Parameter List.
Later software versions: Additional parameters might be available on the SIMOTRAS HD (i.e. extra
functions might be available which are not described in these Operating
Instructions) or some parameters might have an extended setting range. In this
case, leave the relevant parameters at their factory setting, or do not set any
parameter values which are not described in these Instructions !
The software version of the SIMOTRAS HD can be read in parameters r060 and r065.
The latest software version is available at the following Internet site:
http://www4.ad.siemens.de/view/cs/en/8479576
From software version 1.5, the SIMOREG software also contains the SIMOTRAS HD software.
The reproduction, transmission or use of this document or contents is
not permitted without express written authority. Offenders will be
liable for damages. All rights, including rights created by patent grant
or registration of a utility model or design, are reserved.
We have checked that the contents of this publication agree with the
hardware and software described herein. Nonetheless, differences
might exist and therefore we cannot guarantee that they are
completely identical. The information given in this publication is
reviewed at regular intervals and any corrections that might be
necessary are made in the subsequent printings. Suggestions for
improvement are welcome at all times.
SIMOTRAS HD ® is a registered trademark of Siemens
To Next Page
Loading...
