Siemens Sinamics G120 CU240S DP - Page 150

Functions
5.11 Operation in fieldbus systems
Frequency inverter
150 Operating Instructions, 08.10. 2008, t.b.d.
USS communication network via RS 485 with a CU240E
The diagram shows the RS 485 terminals (29/30) and the DIP
switches at the CU240E for the terminating resistor. The default
position is OFF (no terminating resistor).
2))21


* * *
212))2))
6FUHHQLQJ
)LQDO56VODYH
56
0DVWHU
7HUPLQDWLRQ
UHVLVWRU
&8(
56VODYH
&8(
56VODYH
&8(
Figure 5-14 USS network via RS 485
USS communication network via RS 485 with a CU240S
The connection is established using the
SUB D connector located on the lower side
of the Control Unit.
The diagram shows the DIP switch for the
terminating resistor at the CU240S. The
default position is OFF (no terminating
resistor).
2))21
68%' 68%' 68%'
* * *
212))2))
6FUHHQLQJ
)LQDO56VODYH
56
0DVWHU
7HUPLQDWLRQ
UHVLVWRU
&86
56VODYH
&86
56VODYH
&86
Figure 5-15 USS network via RS 485