31400 STEP_RESOL EXP, A01 G2
- Steps per motor revolution (semi servo) DWORD PowerOn
CTEQ
808d-me42 1 10000 100 100000 1/1 M
808d-me62 1 1000 100 100000 7/2 M
808d-te42 1 10000 100 100000 1/1 M
808d-te62 1 1000 100 100000 7/2 M
808d-mte40 1 10000 100 100000 1/1 M
808d-mte60 1 1000 100 100000 7/2 M
Description: Steps per motor revolution (semi servo)
31600 TRACE_VDI_AX EXP, N06 -
- Trace-specification for axial VDI signals BOOLEAN PowerOn
NBUP
- - FALSE 0 - 1/1 M
Description: This machine data determines whether the axial VDI signals for this axis are recorded
in the NCSC trace (according to MD18794 $MN_MM_TRACE_VDI_SIGNAL).
32000 MAX_AX_VELO A11, A04 M3, TE1, TE3, W6, Z3, H1, K3,
M1, P2, A3,
B2, G2, H2, S1, V1,
W1
mm/min, rev/min Maximum axis velocity DOUBLE NEW CONF
CTEQ
808d-me42 - 10000., 10000.,
10000., 36000.
(1e-9/ 1e-9) (1.e300/ 1.e300) 2/2 M
808d-me62 - 10000., 10000.,
10000., 36000., 36000.
(1e-9/ 1e-9) (1.e300/ 1.e300) 2/2 M
808d-te42 - 10000., 10000.,
10000., 36000.
(1e-9/ 1e-9) (1.e300/ 1.e300) 2/2 M
808d-te62 - 10000., 10000.,
10000., 36000.,
36000., 36000.
(1e-9/ 1e-9) (1.e300/ 1.e300) 2/2 M
808d-mte40 - (10000./3000),
(10000./3000),
(10000./3000),
(10000./3000), (100...
(1e-9/ 1e-9) (1.e300/ 1.e300) 2/2 M
808d-mte60 - (10000./3000),
(10000./3000),
(10000./3000),
(10000./3000), (100...
(1e-9/ 1e-9) (1.e300/ 1.e300) 2/2 M
Description: Maximum velocity at which the axis can permanently travel. The value limits both the
positive and the
negative axis velocity. The axis traverses at this velocity, if rapid
traverse has been programmed.
Depending on the MD30300 $MA_IS_ROT_AX, the maximum rotary or linear axis velocity has
to be entered.
In the machine data, the dynamic behavior of the machine and drive and the limit
frequency of the actual value acquisition must be taken into account.
Machine data
3.4 Axis-specific machine data
Parameter Manual
240 List Manual, 01/2017
To Next Page
Loading...
