Siemens SINUMERIK 808D - Read Protection Level of Part Program; Enter Part Program Protection Level; Protection Level Program Selection; Protection Level Write R Variables

213 USER_CLASS_READ_PROGRAM - -
- Read protection level of part program BYTE Immediately
-
- 0 7 0 7 3/3 U
Description: Read protection level of part program
214 USER_CLASS_WRITE_PROGRAM - -
- Enter part program protection level BYTE Immediately
-
- 0 7 0 7 3/3 U
Description: Enter part program protection level
215 USER_CLASS_SELECT_PROGRAM - -
- Program selection protection level BYTE Immediately
-
- 0 7 0 7 3/3 U
Description: Protection level program selection
218 USER_CLASS_WRITE_RPA - -
- Protection level write R variables BYTE Immediately
-
- 0 7 0 7 3/3 U
Description: Protection level write R variables
219 USER_CLASS_SET_V24 - -
- Set RS-232 protection level BYTE Immediately
-
- 0 7 0 7 3/3 U
Description: Protection level Change parameters for RS-232 interface
221 USER_CLASS_DIR_ACCESS - -
- Directory access protection level BYTE Immediately
-
- 0 7 0 7 3/3 U
Description: Directory access protection level
222 USER_CLASS_PLC_ACCESS - -
- PLC project protection level BYTE Immediately
-
- 0 7 0 7 2/2 M
Description: PLC project protection level
223 USER_CLASS_WRITE_PWA - -
- Protected work area protection level BYTE Immediately
-
- 0 7 0 7 3/2 M
Description: Protected work area protection level
Machine data
3.1 Display machine data
Parameter Manual
26 List Manual, 01/2017