Siemens SINUMERIK 808D Parameter Manual

6 PLC user interface....................................................................................................................................471
6.1 Addressing ranges...............................................................................................................471
6.2 Signals from/to the MCP......................................................................................................473
6.3 Reading/Writing NC data ....................................................................................................475
6.3.1 Reading/writing NC data: Job..............................................................................................475
6.3.2 Reading/writing NC data: Result..........................................................................................476
6.4 PI Service.............................................................................................................................476
6.4.1 PI service: Job......................................................................................................................476
6.4.2 PI service: Result.................................................................................................................477
6.5 Retentive data area..............................................................................................................477
6.6 User Alarms.........................................................................................................................478
6.6.1 User alarms: Activating........................................................................................................478
6.6.2 Variables for user alarms.....................................................................................................478
6.6.3 Active alarm response..........................................................................................................479
6.6.4 Alarm acknowledgement......................................................................................................479
6.7 Signals from/to HMI..............................................................................................................479
6.7.1 Program control signals from the HMI (retentive area)........................................................479
6.7.2 Program selection from PLC (retentive area).......................................................................480
6.7.3 Checkback signal: Program selection from HMI (retentive area).........................................480
6.7.4 Signals from HMI..................................................................................................................480
6.7.5 Signals from PLC.................................................................................................................481
6.7.6 Signals to maintenance planners.........................................................................................481
6.7.7 Signals from maintenance planners.....................................................................................482
6.7.8 Signals from operator panel (retentive area)........................................................................482
6.7.9 General selection/status signals from HMI (retentive area).................................................483
6.7.10 General selection/status signals to HMI (retentive area).....................................................483
6.8 Auxiliary functions transfer from NC channel.......................................................................484
6.8.1 Overview..............................................................................................................................484
6.8.2 Decoded M signals (M0 to M99)..........................................................................................485
6.8.3 Transferred T functions........................................................................................................485
6.8.4 Transferred M functions.......................................................................................................486
6.8.5 Transferred S functions........................................................................................................486
6.8.6 Transferred D functions........................................................................................................486
6.8.7 Transferred H functions........................................................................................................487
6.9 NCK signals.........................................................................................................................487
6.9.1 General signals to NCK........................................................................................................487
6.9.2 General signals from NCK...................................................................................................487
6.9.3 Signals at fast inputs and outputs........................................................................................488
6.9.4 Signals from fast inputs and outputs....................................................................................489
6.10 Channel signals....................................................................................................................490
6.10.1 Signals to NC channel..........................................................................................................490
6.10.2 Signals from NC channel.....................................................................................................492
6.11 Axis/spindle signals..............................................................................................................496
6.11.1 Transferred M and S functions, axis specific.......................................................................496
6.11.2 Signals to axis/spindle..........................................................................................................496
6.11.3 Signals from axis/spindle.....................................................................................................499
Table of contents
Parameter Manual
6 List Manual, 01/2017

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English