Bit 2:
Start allowed even if a read-in disable is active; in other words, the blocks of the
ASUB program are
loaded and executed immediately. This therefore disables machine data
MD20107 $MC_PROG_EVENT_IGN_INHIBIT and MD20116 $MC_IGNORE_INHIBIT_ASUP. The NCK
behavior corresponds to the machine data assignment $MC_PROG_EVENT_IGN_INHIBIT=H3F
$MC_IGNORE_INHIBIT_ASUP=HFFFFFFFF.
If the bit is not set:
The assignment of machine data MD20107 $MC_PROG_EVENT_IGN_INHIBIT and MD20116
$MC_IGNORE_INHIBIT_ASUP are evaluated.
If the particular bit in $MC_PROG_EVENT_IGN_INHIBIT or $MC_IGNORE_INHIBIT_ASUP is 0,
then although an ASUB or prog event are immediately internally initiated, the blocks
of the ASUB program are only loaded when the read-in inhibit is withdrawn.
The path is decelerated immediately when the ASUB is triggered (except with option
BLSYNC).
The read-in disable is set once more in the ASUB program.
Bit 3:
If an ASUB is started automatically from JOG, the user may stop in the middle of the
ASUB
program.
JOG
mode is displayed continuously for the user. With bit 3 set, the user
may jog in this situation. This is not possible without bit 3. In this case, mode
change is locked with alarm 16927. By pressing the Start key, the user can continue
the ASUB program. As long as the ASUB program is running, the user is naturally not
able to jog. At the end of the ASUB program, the user may jog again.
Bit 4...15: Reserved
Corresponds with:
MD11604 $MN_ASUP_START_PRIO_LEVEL
MD20105 $MC_PROG_EVENT_IGN_REFP_LOCK
MD20107 $MC_PROG_EVENT_IGN_INHIBIT
MD20115 $MC_IGNORE_REFP_LOCK_ASUP
MD20116 $MC_IGNORE_INHIBIT_ASUP
11604 ASUP_START_PRIO_LEVEL N01 K1, TE3, TE7
- Priorities from which 'ASUP_START_MASK' is effective DWORD PowerOn
-
808d-me42 - 7 0 128 2/2 M
808d-me62 - 7 0 128 2/2 M
808d-te42 - 7 0 128 2/2 M
808d-te62 - 7 0 128 2/2 M
808d-mte40 - 0 0 128 2/2 M
808d-mte60 - 0 0 128 2/2 M
Description: This machine data defines the ASUB priority from which MD11602 $MN_ASUP_START_MASK is
to be applied.
MD11602 $MN_ASUP_START_MASK is applied from the level specified here up
to the highest ASUB priority level 1.
Related to:
MD11602 $MN_ASUP_START_MASK
11610 ASUP_EDITABLE N01 K1
- Activation of a user-specific ASUB program DWORD PowerOn
-
- - 0 0 0x7 2/2 M
Description: This MD determines whether user-specific routine: _N_ASUP_SPF stored in directory
_N_CUS_DIR/ _N_CMA_DIR is to be used to process RET and REPOS. The user ASUB is
searched for first in _N_CUS_DIR.
Machine data
3.2 General machine data
Parameter Manual
List Manual, 01/2017 75
To Next Page
Loading...
Need help?
General
