Glossary
SIPROTEC, 7SJ62/64, Manual
C53000-G1140-C207-2, Release date 01.2008
697
Protection devices
All devices with a protective function and no control display.
Reorganizing
Frequent addition and deletion of objects creates memory areas that can no longer be used. By cleaning up
projects, you can release these memory areas. However, a clean up also reassigns the VD addresses. As a
consequence, all SIPROTEC 4 devices need to be reinitialized.
RIO file
Relay data Interchange format by Omicron.
RSxxx-interface
Serial interfaces RS232, RS422/485
SCADA Interface
Rear serial interface on the devices for connecting to a control system via IEC or PROFIBUS.
Service port
Rear serial interface on the devices for connecting DIGSI (for example, via modem).
Setting parameters
General term for all adjustments made to the device. Parameterization jobs are executed by means of DIGSI
or, in some cases, directly on the device.
SI
→ Single point indication
SI_F
→ Single-point indication fleeting → Transient information, → Single-point indication
SICAM SAS
Modular substation automation system based on the substation controller → SICAM SC and the SICAM WinCC
operator control and monitoring system.
SICAM SC
Substation Controller. Modularly substation control system, based on the SIMATIC M7 automation system.
SICAM WinCC
The SICAM WinCC operator control and monitoring system displays the condition of your network graphically,
visualizes alarms and indications, archives the network data, allows to intervene manually in the process and
manages the system rights of the individual employee.
www . ElectricalPartManuals . com
To Next Page
Loading...
Need help?
General