Siemens SIRIUS 3RW5 - Page 86

Appendix
A.9 Dataset Object
SIRIUS 3RW5 EtherNet/IP communication module
86 Manual, 05/2019, A5E45131885002A/RS-AA/001
Byte Bit Attribute ID
[byte]
Data format Soft starter diagnostics 3RW Type
3)
52
1)
55
2)
10 0 364
[10 ... 15]
BOOL Parameter assignment active - r -
1 BOOL InvalidParameter - r ER
2 BOOL Parameters cannot be changed in ON state - r -
3 BOOL Parameters disable CPU/master active - r -
4 BOOL No external start parameters received - r ER
11 0 BOOL Self-test active - r -
2 BOOL Error during self-test r r ER
3 BOOL Factory settings restored r r -
12 0 UINT Parameter number error
4)
- r -
14 3 BOOL Preset unequal actual configuration r r ER
5 BOOL Temperature sensor overload - r MT
6 BOOL Temperature sensor wire break - r MT
7 BOOL Temperature sensor short-circuit - r MT
15 0 BOOL Parameter set 1 active - r -
1 BOOL Parameter set 2 active - r -
2 BOOL Parameter set 3 active - r -
4 BOOL Parameter set change not possible - r -
6 BOOL Preset unequal actual configuration - r MT
7 BOOL Type of motor connection wrong - r ER
1)
Supported by SIRIUS 3RW52 soft starter
2)
Supported by SIRIUS 3RW55 soft starter
3)
Message type: Error (ER), warning (MT) or other message type (-)
4)
Object number of the faulty parameter from the Dataset Objects parameters and HMI parameters
5)
From 3RW52 V2.0 (if diagnostics are supported), from 3RW55 V2.0.