Siemens SIRIUS 3RW50 - Installing the Standard 3 RW5 HMI into the Control Cabinet Door

Mounting and dismantling
3.4 Connecting the 3RW5 HMI
SIRIUS 3RW50 soft starter
56 Manual, 09/2019, A5E35628455002A/RS-AA/001
3.4.2 Installing the Standard 3RW5 HMI into the control cabinet door
Requirements
● Note the mounting positions, minimum clearances and ambient conditions stated on the
data sheet.
● 3RW5 HMI Standard (accessories)
● HMI connecting cable (accessory) of suitable length connected to the soft starter
(Page 55)
● Cutout of suitable size in the control cabinet door
● Device depth of the 3RW5 HMI Standard:
– Total depth: 32 mm
– Embedded depth: 29 mm
● Permissible wall thickness of the cabinet door:
– Without IP65 door mounting kit: 1.5 to 3.0 mm
– With IP65 door mounting kit: 1.0 to 7.0 mm
For using door mounting kit IP65:
● IP65 door mounting kit (accessory)
The fixing brackets with marking "001" are intended for a 3RW5 HMI Standard.
● Screwdriver PZ2
Procedure without door mounting kit IP65
Place the 3RW5 HMI Standard in the cutout of the control cabinet door ①. Ensure that the
3RW5 HMI Standard engages audibly in the 4 fixtures
②.