Siemens SIRIUS 3RW50 - 3 Rw5 Hmi

Description
1.10 Accessories
SIRIUS 3RW50 soft starter
30 Manual, 09/2019, A5E35628455002A/RS-AA/001
1.10.4 3RW5 HMI
3RW5 HMI Standard
The 3RW50 soft starter can be monitored and controlled using the 3RW5 HMI Standard
(Motor ON/OFF). The 3RW5 HMI Standard can be installed in the control cabinet door or
mounted on a wall using accessories. The 3RW5 HMI Standard has an LCD with red display
illumination, LEDs for status display, and function and control keys.
Functions
● Any changes of setting elements will be indicated immediately in the display.
● Error diagnostics are output as error numbers (Faults and remedial actions of the
3RW50 soft starter (Page 168)).
● Acknowledgment of faults and execution of user tests via the RESET / TEST key
● Starting and stopping the motor via control keys
● Switching modes via the LOCAL / REMOTE key.
● Setting the PROFIBUS station address.
● Display of the device LEDs of the 3RW5 HMI Standard shows the messages of the
following devices:
– 3RW50 soft starter
– 3RW5 HMI Standard
– Communication module (if there is one)
3RW5 HMI High Feature (HF)
Note
3RW5 HMI High Feature
The 3RW50 soft starter is supported by the 3RW5
HMI High Feature as of firmware
version
V3.0.
The 3RW5 HMI High Feature can be used to parameterize, monitor and control (motor ON /
OFF) the 3RW50 soft starter. The 3RW5 HMI High Feature can be installed in the control
cabinet door or mounted on a wall using accessories. It can be connected to the
SIRIUS Soft Starter ES software (TIA Portal) via the local interface.
The 3RW5 HMI High Feature has a TFT color display, LEDs for the status display, and
function and control keys.