8.13.2 Analog output
Operating principle
The set measured value is displayed via the analog output using an external evaluation unit.
Depending on the respective connecting terminal being used, the signal can be displayed either
as current or voltage.
• Terminals: AQ- / AQ I+
Measuring range of current output: 4 - 20 mA
• Terminals: AQ- / AQ U+
Measuring range of voltage output: 0 - 10 V
Requirements
Evaluation unit is connected properly (Page 304).
Setting options
• 3RW5 HMI High Feature
Menu: "Parameters > Soft Starter > Outputs > Analog output"
Access protection to the 3RW5 HMI High Feature is not active or has been reset.
• With SIRIUS Soft Starter ES (TIA Portal) via the local interface on the 3RW5 HMI High Feature
Brief overview: Window "Project Navigation" with current project under created Soft Starter >
"Parameters" > Window "Work area" > "Soft Starter > Outputs > Soft Starter > Analog output"
• With a eldbus via a 3RW5 communication module:
– With SIRIUS Soft Starter ES (TIA Portal) Premium / Professional (only via a 3RW5 PROFINET
or PROFIBUS communication module)
Brief overview: See SIRIUS Soft Starter ES (TIA Portal) via the local interface on the
3RW5 HMI High Feature
– Conguration software of the control system (e.g. STEP 7 with corresponding HSP)
– User program
You can nd additional information on the parameters that can be set via the eldbus in the
manual of the respective 3RW5 communication module.
Functions
8.13 Outputs
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
202 Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006
To Next Page
Loading...
