Siemens SIRIUS 3RW55 - Restoring the Factory Settings with the Master RESET Button Via 3 RW5 HMI High Feature

DANGER
Restoring the factory setting with active Ex operation.
Will cause death or serious injury.
Restoring the factory setting with active Ex operation (Page 207) is not permissible for this
procedure.
To restore the factory setting with active Ex operation, choose the procedure using the master
RESET key on the 3RW5 HMI High Feature (Page 280).
Procedure
1. Select the desired menu item.
– Soft starter
– Communication module
– HMI High Feature
– All devices
2. Con󹪝rm the menu item by pressing the OK key.
Result
The factory setting of the selected device or all devices is restored.
Note the e󹪜ects of the factory settings (Page 278).
10.5.2 Restoring the factory settings with the Master RESET button via 3RW5 HMI
High Feature
Requirements
• Make sure that the motor is switched o󹪜 and you do not start the motor while restoring the
factory settings. To ensure the quickest and most fault-free restoration of the factory setting,
it is recommended that you disconnect the main supply voltage (operational voltage) at the
3RW55 and 3RW55 Failsafe soft starters.
• Free access to the Master RESET key of the 3RW5 HMI High Feature.
Removing the 3RW5 HMI High Feature (Page 60)
• 3RW5 HMI High Feature is connected to the 3RW55 or 3RW55 Failsafe soft starter via the HMI
connecting cable.
Maintenance and service
10.5 Restoring factory setting
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
280 Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006