Siemens SIRIUS 3RW55 - Application Wizard

Switchover options
• 3RW5 HMI High Feature
Menu: "Control > Select parameter set > Parameter set 1 / 2 / 3"
Access protection to the 3RW5 HMI High Feature is not active or has been reset.
Refer to chapter Control via 3RW5 HMI High Feature (Page 232).
• With SIRIUS Soft Starter ES (TIA Portal) via the local interface on the 3RW5 HMI High Feature
Brief overview: Window "Task Card" > Tab "Online Tools" > "SIRIUS Control Panel"
• Input action (Page 194)
• With a 󹪝eldbus via a 3RW5 communication module:
– With SIRIUS Soft Starter ES (TIA Portal) Premium / Professional (only via a 3RW5 PROFINET
or PROFIBUS communication module)
Brief overview: See SIRIUS Soft Starter ES (TIA Portal) via the local interface on the
3RW5 HMI High Feature
– Con󹪝guration software of the control system (e.g. STEP 7 with corresponding HSP)
– User program
You can 󹪝nd additional information on the parameters that can be set via the 󹪝eldbus in the
manual of the respective 3RW5 communication module.
6.3 Application wizard
Operating principle
The application wizard enables easy commissioning by suggesting a suitable selection of
parameters for speci󹪝c applications. A user-de󹪝ned application can additionally be created. The
application wizard can be used for any parameter set.
Setting via 3RW5 HMI High Feature
Menu: "Parameters > Soft Starter > Parameter set 1 / 2 / 3 > Application wizard"
Access protection to the 3RW5 HMI High Feature is not active or has been reset.
Procedure
1. The menu of the 3RW5 HMI High Feature provides you with a list of suggested settings
(Page 93) that is reduced to just the relevant parameters.
All parameters that are not displayed remain unchanged.
2. Check the parameters and modify them if necessary.
Parameter assignment
6.3 Application wizard
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
92 Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006