Mounting/removal
3.1 Redundancy modules
SITOP expansion modules
46 Equipment Manual, 09.2022, A5E36605235-2-76
Removing
To remove, pull up the slider ③ using a screwdriver (see Figure 3-1 Mounting/removal
(Page 46)) and disengage the device at the bottom edge of the standard mounting rail. Then
you can remove the device from the upper edge of the standard mounting rail.
Figure 3-1 Mounting/removal
Use in hazardous zones
If device SITOP RED1200 Ex (6EP4347-7RC00-0AX0) is installed in a hazardous zone (II 3G Ex
ec IIC T4 Gc) then it must be installed in a distribution box with degree of protection IP54 or
higher. This distribution box must comply with the requirements of IEC/EN 60079-0/
GB3836.1 and must require a tool for opening.
To Next Page
Loading...
