Integrating the library contents
6.1 Working with the library in SIMATIC STEP 7
SITOP PSU8600 Firmware V1.3: Faceplates and Communication Blocks V2.3 for SIMATIC STEP 7 V5.5
64 Function Manual, 11.2017, A5E37764016-06-76
Note
The procedure for opening a global library is described in chapter
Opening the library in
(Page 61).
Note
You can now use the blocks you need. However, blocks
SITOP_PSU8600_V2/SITOP_PSU8600_S_V2
(based on the power supply with 4 outputs/1
output) must always be available and called up.
Inserting Text libraries from the library into the program
Follow the procedure to integrate text libraries into a SIMATIC STEP 7 V5.5 project:
In the "SIMATIC Manager", open the required project.
2 Open the "S7 Program" folder available in the connected PLC. Insert Text Library folder under S7 Program
folder if it doesn’t exist.
In the "SIMATIC Manager", open the global library PSU8600 V2-3 STEP 7 V5.5 and select " PSU8600_V2-3”.
The procedure for opening the library is described in Content of the library for SIMATIC STEP 7 V5.5.
5
Copy "SITOP_MODULES", "SITOP_PSU8600_DiagText", "SITOP_PSU8600_HlpText" which are present under
"Text Libraries" folder in the library and paste them into the "Text Libraries" folder of target project folder.
6 Open text library "SITOP_MODULES" and make an entry to the text library with index as modules diagnostic
address and PSU8600/UPS1600 device name under English/ German Language column as shown below.
Save and close text library.
To Next Page
Loading...
