Siemens SITOP PSU8600 - Working with the Library in Wincc Flexible; Overview

Integrating the library contents
6.2 Working with the library in WinCC flexible
SITOP PSU8600 Firmware V1.3: Faceplates and Communication Blocks V2.3 for SIMATIC STEP 7 V5.5
Function Manual, 11.2017, A5E37764016-06-76
73
6.2
Working with the library in WinCC flexible
6.2.1
Overview
System requirements
To use the faceplates in WinCC flexible 2008 SP3, the following requirements must be met.
● SITOP power supply (including the expansion modules) exists.
● The GSD file of SITOP PSU8600 is installed in SIMATIC STEP 7 V5.5 and the PSU is
configured as PROFINET node in the Hardware (HW) configuration of the CPU.
● S7 communication between SITOP PSU8600 and CPU must be configured.
●
All program blocks from the
PSU8600 V2-3 STEP 7 V5.5
library are integrated in
SIMATIC STEP 7 user program and are executable. (See chapter
Working with the
library in SIMATIC STEP 7 (Page 61))
●
The library
PSU8600 V2-3 library WinCC flexible 2008
for WinCC flexible 2008 SP3 is
available.
Supported control panels
Faceplates are approved for the following control panels:
● TP270 10“
● OP270 10“
● MP270 10“ Touch
● MP277 8“ Touch / Key
● MP277 10“ Touch / Key
● MP377 Touch / Key
● WinCC flexible Runtime 2008 SP3
Supported languages
Faceplates support the following languages:
● English (USA)
● German (Germany)
● Chinese (PR China)