Siemens sitrans PROBE LU - Startup Procedures; Startup Display and RUN Mode

Page 10 SITRANS Probe LU (HART) – OPERATING INSTRUCTIONS A5E32337695
Specifications
Approvals (verify against device nameplate)
•General CSA
US/C
, FM, CE, RCM
• Hazardous Intrinsically Safe: (Europe) ATEX II 1 G Ex ia IIC T4 Ga
(US/Canada) FM/CSA: (barrier required)
1
Class I, Div. 1, Groups A, B, C, D
Class II, Div. 1, Groups E, F, G
Class III T4
(International) IECEx SIR 13.0008X Ex ia IIC T4 Ga
(Brazil) INMETRO DNV 12.0070X
Ex ia IIC T4 Ga
IP67/IP68
-40 ºC
≤ Ta ≤ +80 ºC
DNV #OCP 0017
ABNT NBR IEC 60079-0:2008
ABNT NBR IEC 60079-11:2009 e
ABNT NBR IEC 60079-26:2008
Non-incendive (US) FM
2
:
Class I, Div. 2, Groups A,B, C, D T5
• Marine Lloyd’s Register of Shipping
ABS Type Approval
1.
See FM Intrinsically safe connection drawing on page 99 or CSA Intrinsically Safe
connection drawing
on page 100.
2.
See FM Class 1, Div. 2 connection drawing on page 101.
Note: Approved dust-tight and water-tight conduit seals are required for outdoor Type
4X / NEMA 4X, Type 6 / NEMA 6, IP67
, IP68 locations.