EasyManua.ls Logo

Siemens ST750 - Wimag

Siemens ST750
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification
Error! Unknown document
property name.
Page
75 of 75
Version 008
Status
Released
Last Editor Nathan Fearnhead
Date
16/06/2017
Document Name Configuration Control
Document No.
667/CC/32750/000
Copyright © Mobility 2017. All Rights Reserved. Mobility is a division of Siemens Plc
If the internal backup battery is fitted, the Stratos Outstation can be mounted in
any orientation apart from front panel facing down.
Figure 92
Stratos Outstation in Large ST900 Outer Cabinet
4.11 WiMag
WiMag (P/N 667/1/47200/000) is not included in the Outercase ordered from Table 6 and
therefore must be specified separately. The following configuration procedure details a basic
controller WiMag installation into an LV Controller. Full system installation details should be
sought from the WiMag Detection System General Handbook.
Note: The WiMag option can only be installed in both the Small and Large Outercase
versions of the ST750LV Controller.
Refer Figure 93, the Loop Detector Replacement Card (P/N 667/1/47280/000) is a direct WiMag
replacement version of a standard loop detector card (i.e. SLD4). The Loop Detector
Stratos
Outstation
Unit in 19”
Rack
Assembly in
its primary
position.
SLD4
replaces
ST4S
shown

Table of Contents

Other manuals for Siemens ST750

Related product manuals