4.11.2 Intelligent Detector Backplane Card Rotary Address Switch ................. 55
4.11.3 Loop Detector Power ............................................................................ 55
4.12 Loop Detector Cards ............................................................................................ 56
4.13 LSLS Card and Backplane ................................................................................... 56
4.13.1 LSLS Outputs ....................................................................................... 57
4.13.2 LSLS Addressing.................................................................................. 58
4.13.3 LSLS Status LEDs ................................................................................ 59
4.14 Manual Panel ....................................................................................................... 60
4.14.1 Manual Panel LEDs .............................................................................. 61
4.14.2 Signals On/Off Switch .......................................................................... 62
4.14.3 Lamp Test Button ................................................................................. 62
4.14.4 Stage Select Buttons (All Red, 1 - 7) .................................................... 62
4.14.5 Mode Select Buttons (Manual, VA, Fixed Time, Etc) ............................ 62
4.15 Audible Driver Module .......................................................................................... 63
4.15.1 Audible Driver Module - Single Output type (obsolete) ......................... 63
4.15.2 Monitored Audibles – Single Output type .............................................. 65
4.15.3 Dual Level Audibles – Single Output type ............................................. 66
4.15.4 Audible Driver Module - Dual Output type ............................................ 67
4.15.5 Connections for Dual Level Audibles - Dual Output type ...................... 72
4.16 Pedestrian Tactile Indicators ................................................................................ 73
4.17 ELV Solar Cell ...................................................................................................... 76
4.18 Above Ground Detectors ...................................................................................... 77
4.19 Regulatory Signs Expansion Kit ........................................................................... 77
4.20 Detector Power Extension Kits ............................................................................. 80
4.21 ELV Compatible Nearside, Wait and Demand ...................................................... 82
5 User Interface .................................................................................................................. 83
5.1 Connection ........................................................................................................... 83
5.2 Types of User Interface ........................................................................................ 83
5.2.1 Web Browser ........................................................................................ 83
5.2.2 WIZ ...................................................................................................... 84
5.2.3 Handset ................................................................................................ 84
6 Fitting the Controller into Alternative Cabinets ................................................................. 85
7 Installation and Commissioning Procedure ...................................................................... 89
7.1 Service-Centre Cabinet Testing ........................................................................... 89
7.2 Checking Site Suitability ....................................................................................... 90
7.2.1 Site Cable Installation ........................................................................... 90
7.3 Cabinet Installation ............................................................................................... 91
7.3.1 Order of Installation .............................................................................. 91
7.3.2 Removal of Controller Electronics ........................................................ 91
7.3.3 Removal of Stool from Outer case ........................................................ 92
7.3.4 Removal of CET bars ........................................................................... 92
7.3.5 Installation of Stool ............................................................................... 92
7.3.6 Cable Installation to Controller.............................................................. 93
7.3.7 Refitting CET bars ................................................................................ 93
7.3.8 Terminate the cable armouring ............................................................. 94
7.3.9 Cable Testing ....................................................................................... 94
7.3.10 Re-fit the Cabinet to the Stool .............................................................. 95