SigTEL Compact - 20 Installation and Commissioning Certificate

SigTEL Compact Installation and Configuration Manual
SigTEL Approved Document No. DAU0000091 Rev 5 Page 35 of 36
Emergency Voice
Communication System
20 Installation and Commissioning Certificate
Before the system and the Operator Instructions are handed over to the responsible person on site, the following
certificate should be completed by the installer, or commissioning engineer.
Certificate for the EVCS at:
Address:
I/we being the person(s) responsible (as indicated by my/our signatures below) for the supply, installation and
commissioning of the EVC
S
, particulars of which are set out below, certify that the system complies to the best
of my/our knowledge and belief with the
recommendations of BS5839-9
, except for the variations, if any, stated
in this certificate.
Name (in block letters):
Position: ………………………………….
Signature:
Date:
For and on behalf of:
Address:
Postcode:
The extent of liability of the signatory is limited to the system described below.
Variations (see BS5839-9, Clause 6): ………………………………………
All equipment operates correctly.
The following documents have been provided to the purchaser or user:
‘As fitted’ drawings.
Operating and maintenance instructions.
Sufficient representatives of the user have been properly instructed in the use of the system.
Maintenance
It is strongly recommended that, after completion, the system is tested, inspected and serviced in accordance
wi
th Section five of BS5839-9.
The user should appoint a responsible person to supervise all matters pertaining to the EVCS in accordance
with the recommendations
of Section six of BS 5839-9.