12
Single-Area Operation
Note: Multi-area instructions are on page 18.
For a typical single-area installation, pressing a
button on the touchpad simply toggles the function
on or off (see page 5 for touchpad button
descriptions). However, depending on how the
installer programs your system, the touchpad may
prompt you to first enter a code or enable you to use
interactive menus to activate functions.
Since the operating instructions for a toggle system
vary slightly from a menu system, both methods of
operation are included in this section. Your installer
can tell you what method to use and check (
;
)
which options are programmed for your system.
U
U
Arming/Disarming the Entire System
When your system is armed, your building is
protected so that alarms will sound if the system
senses an intruder.
When your system is disarmed, you can move freely
throughout the premises without causing an alarm.
U
Toggle Method
Enter your code.
Your system may be programmed to automatically
arm the interior zones when you enter your code. If
your system is not programmed this way, first press
INT
to arm the interior zones.
U
Menu Method
Users can arm/disarm only the areas they can access.
1. Enter a code. A STATUS: display on the LCD
indicates that you are in the interactive menus
(see page 31 for system status messages).
2. If your system is not programmed to
automatically arm the interior zones when you
arm the system, press
INT 9
to turn on interiors
or
INT 0
to turn off interiors.
3. Press
to arm or to disarm.
What Happens
The LCD will return to the normal display.
To Next Page
Loading...
Need help?
General
