37
System Messages
Your system communicates with you primarily through the touchpad. Refer to the following list if you need more
information about a message that appears on your touchpad LCD. Messages are in alphabetical order.
Access code not
verified
An invalid access code was entered. A valid entry is 4 to 8 digits.
Access Denied.
First line. Reasons display on the second line (explained below).
Can Not Arm
The user does not have any arming privileges.
Can Not Disarm
The user does not have privileges to disarm the system.
Can Not Reset
The user does not have privileges to reset the system.
CODE2 Not Active
The Code 2 feature must be active (enabled by any code other than Code 2) and
within a valid timeframe before the user is granted access.
CODE2 User
A Code 2 user tried to perform a function that is not allowed by a Code 2 user.
No Common Areas
The user does not have access to all areas.
Normal User
A Normal user tried to perform a function that is not allowed by a Normal user.
Outside Time Win
The user entered a valid code, but is not allowed access at this time. Access is
limited to a specific timeframe.
To Zone <
number
>
The user cannot bypass the zone indicated.
To Next Page
Loading...
Need help?
General
