18
Multi-Area Operation
For multi-area installations, the system is divided
into multiple areas for separate access and arming
capabilities in each area of the building.
How you operate your system depends on how your
system is configured. In a toggle system, pressing a
button on the touchpad simply toggles the function
on or off (though you may have to first enter your
code). The function activated or deactivated affects
only the areas that you are allowed to access. See
page 5 for touchpad button descriptions.
In a menu system, an interactive menu guides you
through a particular task by displaying options for
your area. You can activate functions by selecting
options from these menus. Figure 3 shows the main
interactive menu display.
Since the operating instructions for a toggle system
vary slightly from a menu system, both methods of
operation are included in this section. Your installer
can tell you what method to use and which options
(
;
) are programmed for your system.
AREAS:RRA
A
----
0-Disarm/Reset
1bUQc !(
1fQY\QR\U
?`dY_^c
H 3b_cc 1\Qb]
1 1b]UT
4 1b] 4U\Qi
D Db_eR\U
> >_d BUQTi
B BUQTi d_
RU Qb]UT
1 9^ Q\Qb]
XQfU QSSUcc d_ QbUQc %( _b dXUi T_ ^_d UhYcd
?^ dXYc TYc`\Qi QbUQc ! Q^T " QbU TYcQb]UT QbUQ #
Yc Qb]UT Q^T QbUQ $ Yc Y^ Q\Qb] DXU ecUb T_Uc ^_d
6Ybcd <Y^U
CUS_^T <Y^U
area_arm
Figure 3. Interactive Main Menu
Special Information for Multi-Partition
Maintenance Personnel
If you have access to multiple partitions within a
system, you will need to enter the number of the
partition before you perform any functions in the
partition. (In a UL listed installation, multi-
partitioning can be used only in single-owner
installations.)
To Next Page
Loading...
Need help?
General
