21
Menu Method
If your system is not programmed to automatically
arm the interior zones when you arm the system,
follow these steps:
1. Enter a code to access the interactive menus.
2. For all areas, press
to arm or to disarm
(for individual areas first select the area number).
3. Press
ENTR ENTR
to return to the normal
display.
If your system is programmed to automatically arm
the interior zones when you arm the system, you will
have to turn off the interior zones in each area before
arming. Use the following steps:
1. Follow Steps 1-3 above.
2. Enter the number of the area where you want to
turn off the interior zones.
3. Press
INT
. (Your system must be programmed
for interior zones in this area).
Repeat Steps 2 and 3 for each area where you
want to turn off the interior zones.
4. Press
ENTR
to return to the normal display.
What Happens
When you arm the perimeter zones, the ARMED
LED is on. If the INTERIOR LED is also on, then
the interior zones are also protected. When the
INTERIOR LED is off, you can move freely within
the interior zones, but the perimeter zones are armed.
Flashing LEDs indicate that not all areas are armed.
Arming/Disarming with Entry/Exit Delays
Delay times give you time to leave your building
after arming and return to your building to disarm
your system without setting off alarms. The same
instructions for “Arming/Disarming All Areas”
applies; however, you must enter your access code
within a specified number of seconds. (The number
of seconds is programmed by your installer.)
The system beeps as the LCD displays the number of
seconds before the system arms or an alarm sounds.
To Next Page
Loading...
Need help?
General
