20
system is armed. Flashing indicates that only some
areas are armed.
When your system is disarmed and all zones are
ready, the ARMED LED is off and the green
READY LED is on.
Arming/Disarming a Specific Area
Users can arm/disarm only the areas they can access.
(Operates the same for all systems.)
1. Enter a code. When
STATUS:
displays on the
LCD, it indicates that you are in the interactive
menus (see page 31 for system status messages).
2. Enter the number of the area that you want to
arm or disarm.
3. Your system can be programmed to
automatically turn on the interior zones when you
arm an area. For systems not programmed this
way, press
INT
to arm the interior zones.
4. Press
to arm this area or to disarm.
Repeat Steps 2-4 for each area you want to arm.
5. Press
ENTR ENTR
to exit.
What Happens
When your system is armed, the ARMED and
INTERIOR LEDs are on. Flashing LEDs indicate
that some areas are disarmed (the area you just
armed will still be armed).
When your system is disarmed, the ARMED LED is
off and the green READY LED is on.
Arming/Disarming Perimeter Zones
You can arm only the perimeter zones, enabling free
movement throughout interior zones.
Toggle Method
1. Enter your code.
2. If your system is programmed to automatically
arm the interior zones when you enter your
code, press
INT
to turn off the interior zones.
To Next Page
Loading...
Need help?
General
