14
Activating Auto Arm
Note: Auto Arm cannot be used in UL installations.
If your system is programmed for the Auto Arm
feature, it can arm itself automatically. All you have
to do is enter the number of minutes for the system
to count down before arming.
When you set the arm time, the display will always
show the default time of 10 minutes, not the previous
arm time. (This option is not available with toggle
systems.)
1. Enter a code. A
STATUS:
display on the LCD
indicates that you are in the interactive menus
(see page 31 for system status messages).
2. Press
1
for Set Arm Time.
3. Enter the number of minutes before auto arming
goes into effect, then press
ENTR
(or just press
ENTR
to accept the default number of minutes).
4. Press
ENTR
to return to the normal display.
What Happens
The LCD will return to the normal display and the
next automatic arming will occur at the new time.
A warning message displays telling you how many
minutes are left before automatic arming begins.
Cancelling Auto Arm
If your system is programmed to arm automatically,
you can manually turn off this feature.
Resetting the time and date (page 29) automatically
cancels auto arming or you may enter zero minutes
for the Arm Time. (This option is not available with
toggle systems.)
To cancel the time when automatic arming would
occur:
1. Enter a code to activate the interactive menus.
2. Press
1
for Set Arm Time.
3. Press
CLR 0
to erase the default number of
minutes (10) before auto arming goes into effect,
then press
ENTR
.
To Next Page
Loading...
Need help?
General
