22
Activating Auto Arm
Note: Auto Arm cannot be used in UL installations.
If your system is programmed for the Auto Arm
feature, the system can automatically arm itself. All
you have to do is enter the number of minutes for the
system to count down before arming.
Note that when setting the arm time, the display will
always show the default time of 10 minutes (not the
previous arm time).
1. Enter code to activate the interactive menus.
2. Enter the number of the area in which to initiate
auto arming.
3. Press
1
for Set Arm Time.
4. Enter the number of minutes before auto arming
goes into effect, then press
ENTR
(or just press
ENTR
to accept the default number of minutes).
5. Repeat Steps 2-4 to activate auto arming in other
areas, or press
ENTR
t
o exit.
6. Press
ENTR
to return to the normal display
.
*Note: This feature is not available with toggle systems.
What Happens
The LCD will return to the normal display and the
next automatic arming will occur at the new time. A
message appears after the normal display messages
warning you of how many minutes are left before
automatic arming begins.
To Next Page
Loading...
Need help?
General
