Silvercrest SSMS 600 E6 - Safety Instructions; Risk of Electric Shock; Warning: Risk of Injury

■ 4
│
GB
│
IE SSMS 600 E6
We recommend the following operating times:
Allow the hand blender 5 to cool down for around 2 minutes after 1 minute of
operation.
Let the liquidiser cool down for around 2 minutes after 1 minute of operation.
Allow the whisk q to cool down for around 10 minutes after 3 minutes of operation.
If you exceed these operating times, the appliance can overheat and be damaged!
Safety instructions
RISK OF ELECTRIC SHOCK
► Connect the appliance only to mains power sockets supplying
a mains power voltage of 220 – 240V∼, 50 – 60 Hz.
► Remove the plug from the mains power socket in event of
operating malfunctions and before cleaning the appliance.
► Do not expose the appliance to moisture and do not use it
outdoors.
► If liquid gets into the housing, disconnect the appliance from
the mains power socket immediately and have it repaired by
a qualified technician.
► Always pull on the plug to disconnect the appliance from the
mains; never pull on the power cable itself.
► Do not kink or crush the power cable, and route the cable so
that it cannot be stepped on or tripped over.
► To avoid potential risks, if the appliance power cable is da-
maged, it must be replaced by the manufacturer, its customer
service or by a qualified technician.
► This appliance may be used by people with reduced physical,
sensory or mental capabilities or lack of experience and/or
knowledge if they are supervised and have been instructed
in how to use the appliance safely and have understood the
potential risks.
► The appliance and its connecting cable must be kept away
from children.