EN
6. Basic Setup
35
Basic Setup
6.
BATTERY - Here you can assign your shunt to a battery. More common way is to assign shunts to a battery through the
battery configuration screen.
DISPLAY SEPARATELY - If enabled, the shunt will be displayed in separate screen, even if the shunt is assigned to a battery.
DISPLAY PRIORITY - Set the display priority of the current sensor. Here you can also hide the current sensor.
DEVICE - Displays a full ID of the current sensor. This is read only and it will not change even if you rename the sensor.
MERGE WITH - Gives you an option to merge the sensor with another sensor. That way you tell PICO to consider the
readings of two current sensors as a reading of a single device.
To Next Page
Loading...
Need help?
General
