This section describes all the menus that are currently available.
Normally, the menus are divided into three menu lists. These are the Main Menu list,
the Setup Menu list and the User Options Menu list.
In the default configuration, the Main Menu contains the Channel, Zone and Setup
menus. This allows access to the second ‘Setup’ menu level.
The Main Menu can be accessed from the default screen by selecting the ‘Menu’ (F1)
button.
To access any of the menu options from the Main, Setup or User Options Menus, use
the ▴ and ▾ keys to scroll through the lists until the required menu option is selected
with the pointer (▸) and then press the ‘Select’ (F1) button.
Pressing the ‘Back’ (F4) key at any point will go back to the previous screen.
Home Screen (Channel & Zone)
The default home screen shows the currently selected channel & current zone.
The ▴ and ▾ keys scroll through all available channels within the currently selected
zone.
By changing the zone, other groups of channels – or indeed other modes of system
operation (DMR Tier II, DMR Tier III or Analogue) – are made available to the user.
Figure 15: Home Screen
To change the zone:
1. Press the Menu button.
2. Scroll down to Zone with the ▴ and ▾ keys and then press the Select key
3. Select the Zone using the ▴ and ▾ keys and then press Select again.
Other menu items and screen displays are dependent on the radio programming done
by your Dealer; examples of possible alternate screen displays are listed below
alphabetically.
Alert Offset
This menu allows the user to set the offset of the Alert Volume in relation to the
current Volume setting. Thus, the alert tones can be made louder or softer than the
Document Number: TNM-U-E-0145 Issue: 1.0 Page 20
To Next Page
Loading...
Need help?
General
