Simoco SDM600 Series User Manual

3 Basic Operation
Turning the Radio On and Off
Pressing the red On/Off button briefly will switch the radio On. After a brief delay the
display will revert to the Idle Screen, at which time the radio is ready for use. The radio
can be programmed to automatically power-up in DMR or Analogue modes.
Pressing and holding the red On/Off button for approximately 2 seconds will switch
the radio Off.
Figure 4: Idle Screen
If the radio Inactivity Timer is enabled, the radio will automatically turn off after a
preset period of inactivity (i.e. no buttons pressed by the user). Prior to switching off,
the radio will emit warning beeps for 10 seconds. Pressing any button will reset this
timer.
The radio can also be set up to switch on automatically with the Vehicle Ignition
whenever the vehicle is started.
Password Screen
The FPP has a ‘Password’ option. If enabled, then the radio will wait for the user to
enter a 4-digit number before the radio will enter the operational state.
When entering the 4-digit numeric password, a '*' will be displayed for each key press.
After the 4th numeric key press, the radio will display the welcome screen if the
password was correct.
Figure 5: Password Screen
Document Number: TNM-U-E-0145 Issue: 1.0 Page 9

Simoco SDM600 Series Specifications

General

Brand	Simoco
Model	SDM600 Series
Category	Radio
Language	English