Simplex 4100+ User Manual

22
There are two types of acknowledges for the 4100 system: Global Acknowledge and Individual Acknowledge. Each
acknowledge type operates with the Supervisory Service Condition in the following manner:
• Global Acknowledge – When Global Acknowledge is used on the 4100 system, a single key press of the
<SUPV ACK> key acknowledges all supervisory service changes in the system. If status change information
is required, you may review this data (after a 30-second delay) by pressing the <SUPV ACK> key and reading
the total number of supervisory service changes on the alphanumeric display.
• Individual Acknowledge (For NFPA 72 Proprietary Receiver Requirements) – If a supervisory service
condition has been acknowledged with the <SUPV ACK> key and further unacknowledged conditions remain
in the system, the tone-alert continues to sound and the next status change is shown on the alphanumeric
display. This process repeats until all changes are acknowledged. When this occurs, the tone-alert silences
and the highest priority acknowledge change appears on the display.
firealarmresources.com

Simplex 4100+ Specifications

General

Type	Addressable Fire Alarm Control Panel
SLC Loops	Up to 10
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	10% to 93% non-condensing
Display	LCD
Communication	Ethernet
Power Supply	120/240 VAC, 50/60 Hz
Battery Backup	24 VDC
NAC Outputs	Expandable
Releasing Capability	Yes, with releasing modules
Max Notification Appliance Circuits (NACs)	Varies by modules
Max Releasing Circuits	10
Communication Ports	Ethernet
Max Devices	3, 000