Sleep mode
In Sleep mode, the backlight for screen and keys are turned off to
save power. The system continues to run in the background.
To enter Sleep mode press and hold the power key or select Sleep
from the Display Setup dialog activated by pressing the power key.
Switch from Sleep mode to normal operation by a short press on
the power key.
Ú
Note: The system will automatically switch to Standby mode
when Sleep mode is activated.
Operating the menu system
All settings and configuration in the unit are available from the
Settings menu, activated by pressing the MENU key.
• Turn the rotary knob to move up and down in the menus and in
the dialogs
• Confirm a selection by pressing the rotary knob
• Return to previous menu level by pressing the X key
Edit a value
1. Turn the rotary knob to select the entry field
2. Press rotary knob to turn the field into edit mode
-
The left digit starts flashing
3. Turn the rotary knob to set the value for the flashing digit
4. Press the rotary knob to move focus to the next digit
5. Repeat step 3 and 4 until all digits are set
6. Press the rotary knob to leave edit mode for the selected field
Selected field
Field in edit mode
Ú
Note: You can at any time press the X key to leave a dialog.
14
Basic operation | AP™ 48 Operator Manual
To Next Page
Loading...
Need help?
General
