Pilot menu & navigation examples Chapter 6-15
Next destination: While on the way, you can easily move the cursor
to the next destination, and when ready to change navigation leg...
GOTO
Call up the GOTO menu
2
Restart to approaching point
- a new course line will be drawn from ship’s position to destination.
To turn NAV mode off again: Press [GOTO], [3].
6.9.2 Waypoint navigation
To start Waypoint navigation will require that at least one waypoint
is stored in the memory. Refer to section 4.4.9 PLOT menu.
CHART
Shortcut to chart display
Place cursor on destination waypoint
GOTO
Call up the GOTO menu, and...
2
Select Waypoint navigation mode
This will activate the pop-up window “Navigate to WP” - and if the
highlighted waypoint is the point you wish to sail to, then just press
[ENT] to start navigation.
However, if you wish to sail to a different waypoint:
+/-
Scroll up/down in the waypoint list, or...
0-9
Key in the number/name of the waypoint you wish to sail to
ENT
Start navigation
A course line will now be drawn from ship’s position to destination
waypoint.
To turn NAV mode off again: Press [GOTO], [3].
CX34/44/54 Operator manual
To Next Page
Loading...
Need help?
General
