C-MAP attributes Appendix C-7
Objects organized in categories
The purpose of the C-MAP functions is to select objects, which are to be dis-
played on the screen (chart). The objects are organized in categories and each
category can be selected as one, without having to decide upon almost 300
objects separately. Refer to section 4.5 Chart setup.
The following functions are used to enable/disable visualization of the catego-
ries listed below:
LAND SETTINGS
Natural features:
Land area and coastline
Hill, dune area
Land contour lines
Salt pan
Slope topline
Tree point
Vegetation area
Natural features rivers:
Lake, Waterfall
River, Canal
Cultural features:
Airport area
Built-up area
Railway
Road in general
Overhead cable, w/pylons
Overhead pipeline
Fence line
Telepheric
Bridge
Tunnel, tunnel entrance
Points of interest:
Attractions,
Historic buildings, etc.
Landmarks:
Building, religious / single
Cemetery
Fortifid structure
Siloway route part
Tank, chimney
Dish aerial
Radar dome
Flagstaff / Flagpole
Flare stack
Mast, Tower, Monument
Windmill, windmotor
Traffic:
Roads, railroads, etc.
MARINE SETTINGS
Names:
Text
Nav-Aids/Lights/Light
Sectors:
Lighthouse, Light float
Lighted offshore platform
Light in general
Signals:
Anchor point, Cairn
Chain / Wire, Fog signal
Radar reflector, Top mark
Navigational aid, generic
Extended nav.aid, generic
Radar station
Radar transponder beacon
Radio station
Buoys:
Cardinal
Installation
Isolated danger
Lateral
Safe water
Special purpose
Generic
Attention Areas:
- see Caution Areas
Tides, currents:
Tide height (predictions)
Current
Water turbulence
Nature of seabed:
Seabed area, rocky area,
coral reef
Weed / kelp
Sand waves
Spring in seabed
CX34/44/54 Operator manual
To Next Page
Loading...
Need help?
General
