EQ42/50/52 SETUP menu Chapter 7
40
To activate one of the functions in the “Factory presets” display, please
follow the instructions in the display, or exit without making any
changes by pressing [MENU].
Attempting to make any type of change from this display will first of
all generate a WARNING display that you are about to7 erase some or
all data/settings.
If you are absolutely sure, press
[ENT]
to complete the job.
If not absolutely sure, then press [MENU] to exit the function.
Poweroff-Reset
In case, for some reason, the unit is totally locked i.e. no immediate
response from the keypad, then first try to reset the unit by discon-
necting the power supply. Reconnect the power cable and then start up
the unit again by pressing and holding the [PWR] key until a picture
appears on the screen.
Master reset (will return all settings to factory presets)
If the Power off - reset does not solve the problem, you may have to
perform a master reset by disconnecting the power supply, and then
while reconnecting the power cable you need to press the [PWR] +
[CLR] keys at the same time, and hold both keys depressed until a
picture appears on the screen.
Show test display
Information in this display is for technicians only.
To Next Page
Loading...
