Arrival alert
When the arrival alert is enabled, an alert is activated when the
vessel reaches the waypoint or when it is within the specified arrival
radius.
Arrival radius
Sets an invisible circle around the destination waypoint. The vessel
is considered arrived at the waypoint when it is within this radius.
When you are navigating a route, the arrival radius defines the point
at which a turn is initiated.
The arrival circle (1) should be adjusted according to boat speed.
The higher the speed, the wider the circle.
The figure below may be used to select the appropriate waypoint
circle when creating the route.
Ú
Note: The distance between any waypoints in a route must not
be smaller than the radius of the waypoint arrival circle.
Software setup | P2005/P3007 Operator Manual
35
To Next Page
Loading...
Need help?
General
