First time startup
When the unit is started for the first time, or after a factory default,
the unit displays a series of dialogs. Respond to the dialog prompts
to make fundamental settings.
You can perform further setup and later change settings using the
system settings dialogs.
Software setup sequence
This chapter describes the software setup options as they appear in
the menu system.
All relevant areas listed must be addressed during commissioning,
and they should be stepped through in the listed sequence.
1 "Ethernet setup" on page 42
• Define this device on the Lightweight Ethernet
2 "Local port setup" on page 36
• Configure the two NMEA 0183 ports
• Configure the digital port
3 "Junction box setup" on page 45
• Configure the ports on a junction box connected via
NMEA 2000
4 "NMEA 2000 setup" on page 40
• Make sure that the global NMEA 2000 data sources have
been selected
5 "Display sources" on page 39
• Select sources for this device if these are to be different
from the global NMEA 2000 sources
6 "GNSS settings" on page 32
• Define the GPS settings and configure the GPS source
When the required start-up settings are done, you should page
through all the remaining settings and confirm that they are as
desired.
Software setup | P2005/P3007 Operator Manual
27
To Next Page
Loading...
Need help?
General
