Ú
Note: A unique SFI must be assigned to the digital port if this is
to be part of the LWE network.
Speed log input
It is possible to configure the digital port for speed input.
Ú
Note: Only speed logs outputting 200 pulses per nautical mile
are supported.
MOB input
The digital port can be configured for MOB event input.
Calibration
Magnetic variation
Magnetic variation is the difference between true bearings and
magnetic bearings, caused by different locations of the Geographic
and the Magnetic north poles. Any local anomalies such as iron
deposits might also affect the magnetic bearings.
When set to Auto, the system automatically converts magnetic
north to true north. Select manual mode if you need to enter your
own local magnetic variation.
Network settings
Display sources
Used for selecting sources for this device if these are to be different
from the global NMEA 2000 sources.
The display sources can be either NMEA 2000, Lightweight Ethernet
or local sources.
Software setup | P2005/P3007 Operator Manual
39
To Next Page
Loading...
Need help?
General
