Calibration
An offset (positive or negative) can be applied to correct data
inaccuracies from NMEA 2000 sources.
Ú
Note: Any calibrations made here will only be applied locally to
this unit. Other devices on the network will not have these
offsets applied.
Diagnostics
Provides information useful for identifying an issue with the
network.
Lightweight Ethernet
This setting is used for identifying this device on the LWE network.
Device specific settings can be shared with devices belonging to
the same network group.
Ethernet setup
The Ethernet must be assigned with:
• an IPv4 address. Must be in the range 172.16.0.1 to
172.31.255.254, and the IP address must be unique for each
device on the network
• a 4 digit Lightweight Ethernet SFI (System Function ID). The SFI
must be unique for each device on the network.
Ú
Note: If no SFI is entered (remaining with the default 0000
value), the device will not be visible on the LWE network, and it
will not share any data.
42
Software setup | P2005/P3007 Operator Manual
To Next Page
Loading...
Need help?
General
