4
Caution
Injuries
-
To prevent personal injuries or damages to the machine, you need to follow the
below instructions before moving the machine.
Do not open the front and top door during machine operation.
Do not open the rear cover or touch any parts of the rear extruder unit during
machine operation.
When the power is on, do not let any of your body touch the machine except
the bed.
If you have to touch any parts other than the bed, please do so after turning the
power off, removing the power cord from the plug and after the bed and nozzle
temperature have been lowered to room temperature.
Turn the power switch off, then unplug the power cord from the power outlet.
Unplug and release all the cords and cables before moving the machine.
Only use the power cords provided with this machine or cords that are approved by the manufacturer.
Do not put any portion of your body or objects during machine operation, as the bed, motor, nozzle
will be in operation and moving. Small objects such as neckless, hair, etc may cause personal injuries
or damages to the machine.
If any problems occur(malfunction, body part being caught inside the machine, etc) during machine
operation, quickly press the pause
or stop button located on the on the bottom right of the
touch screen located on the bottom right of the upper side.
Nozzle
Bed UI
To Next Page
Loading...
