4.3 Cartridge Replacement
Replace cartridge when a cartridge is used up or a different color/material is needed.
1 Initiate Cartridge Unload.
Reference
-
For details on cartridge unload, please refer to P. 2-5 “UNLOAD”
2 Please switch the cartridge first and then load.
Reference
-
For details on cartridge load, please refer to P. 2-4 “LOAD”
Note
-
When replaced with a different color, the previously used color may be seen in the beginning of printing.
If the color is the only difference from the previous filament, it doesn’t affect the printing quality.
Difference in material, however, may affect the printing quality.
To fix problem, after changing cartridge, please run nozzle cleaning (Refer to P. 2-19 “NOZZLE CLEANING”)
before printing.
4.4 Nozzle Replacement
Methods of Detaching Nozzle
In the UI, press [Cartridge] – [(Select a cartridge to unload)] – [Cartridge to unload], and check if the nozzle is
below 30°C on the liquid crystal display (LCD).Turn off the power, and remove the power cord from the body before
starting work.
Caution
-
If the temperature of the nozzle is above 30°C, it may cause burns to a part of your body during
replacement.
To Next Page
Loading...
