1.5 Cleaning the inside of the Nozzle
The leftover in the nozzle interferes with filaments transfer. This interference can cause problems with printing and
filament loading.
The leftover makes the printing filament uneven or clogs the nozzle.
Once melted, the filament can have different properties from the original.
If the leftover in the nozzle is repeatedly heated / cooled, the properties will be changed.
The changed leftover is harder to pull out, and easily stacked in the nozzle.
Therefore, it is recommended to clean the nozzle regularly if you want to use nozzle for a long time.
Nozzle cleaning is recommended when replacing it to another material of filament. This is because each material has
different properties.
Especially, be sure to clean the nozzle before and after using PVA or flexible material.
Please clean the nozzle as the following instruction.
1 Remove the snap ring from the nozzle.
SNAP-RING
2 Remove the tube from the nozzle.
TUBE
TUBE HOLDER
To Next Page
Loading...
