3. Problems and Solutions
3.1 Iflamentdoesnotcomeoutofthenozzle
Follow the on-screen instructions and start the auto recovery process. After the recovery process if problem
persists follow the below steps.
1 Initiate cartridge unlock. Remove the cartridge from the printer. Use the extruder jog mode to remove the
filament. Cut the removed filament, (Use below image as reference) re-install the cartridge and run LOAD.
Note
Cutting Filament Tip
-
Cut the filament in the way the cut end is sharp as shown below. It makes the filament run through easier.
-
After unloading, turn the cartridge gears for the filament to come out, cut the dented part (approx 50~60cm)
this makes the LOAD easier.
To Next Page
Loading...
