1. Machine Specifications
1.1 Printing
Printing Method Fused Filament Fabrication
Max. Print Length(mm) W(max):228, D(max):200, H(max):300
Print Layer Thickness Setting 0.05~0.4mm
Basic Nozzle diameter 0.4mm
Filament width 1.75mm
Printable materials PLA, ABS, FLEXIBLE, PVA(Water-soluble)
Printable color White, Black, Gray, Red, Yellow, Green, Blue, Pink(PLA), Purple(PLA)
Bed leveling Auto measuring + Manual leveling
Print Head Two Nozzle
1.2 Temperature/Speed
Continuous Nozzle Usage/ Maximum Temperature Recommended Temperature(Nozzle): PLA 200℃, ABS
230℃, Flexible 225℃, PVA 200℃ / Max 250℃
Continuous Bed Usage/ Maximum Temperature Recommended Temperature(Bed): PLA 60℃, ABS
90℃, Flexible 60℃ , PVA 60℃ / Max 100℃
Recommended printing speed/maximum speed 40mm/s Recommended / 200mm/s max
* Continuous operation at maximum temperature can cause malfunction, Please use in case of nozzle clogging or
other troubles.
1.3 Machine
Power 350W
Dimensions 490 x 466 x 573
Weight 31kg (excluding cartridge)
Port USB Device, USB Host , Wifi, Ethernet
Cartridge Auto Load / Unload
1.4 Software/Support
Supported Software Sindoh Exclusive Slicer
Supported File Format *.stl, *.ply, *.obj, *.gcode, *.amf
Supported Operating System Windows 7 or above, Mac OSX 10.10 or above
Recommended Memory Requirements DRAM 8 GB+
Note
-
Graphics must support OpenGL 2.0 or higher.
1.5 Default Setting of Print layer Width
Nozzle Width 0.4mm
Print Layer Width 0.2mm
To Next Page
Loading...
