Chapter 4 Printed Output Check
1. Printed Output Check --------------------------------------------------------------------------------------------------- 4-2
1.1 Detaching Printable ------------------------------------------------------------------------------------------------------- 4-2
1.2 Improving Printing Quality ---------------------------------------------------------------------------------------------- 4-4
2. When Printer Cannot be Turned On ------------------------------------------------------------------------------- 4-5
3. If problems persist ------------------------------------------------------------------------------------------------------ 4-6
Chapter 5 Maintenance
1. Machine Cleaning ------------------------------------------------------------------------------------------------------- 5-2
1.1 Cleaning Case Maintenance ------------------------------------------------------------------------------------------- 5-2
1.2 Printer Interior Cleaning ------------------------------------------------------------------------------------------------- 5-2
1.3 Periodical Inspection ----------------------------------------------------------------------------------------------------- 5-2
Oil/Grease Inspection ----------------------------------------------------------------------------------------------------- 5-2
1.4 Flexible bed and Nozzle Cleaning ------------------------------------------------------------------------------------ 5-2
1.5 Cleaning the inside of the Nozzle -------------------------------------------------------------------------------------- 5-3
1.6 NOZZLE TIP CLEANING ------------------------------------------------------------------------------------------------ 5-8
2. Error Message and Solutions --------------------------------------------------------------------------------------5-10
3. Problems and Solutions ---------------------------------------------------------------------------------------------5-12
3.1 If filament does not come out of the nozzle (Fix for EC401) --------------------------------------------------5-12
3.2 In Cases where Filament is Cut Between the Extruder and Nozzle -----------------------------------------5-13
3.3 When Filament End is Visible Outside the Cartridge After Unloading --------------------------------------5-13
3.4 If the bed leveling does not operate normally ---------------------------------------------------------------------5-14
3.5 Solution for EC 401 ------------------------------------------------------------------------------------------------------5-14
4. Replenishing Consumables ----------------------------------------------------------------------------------------5-18
4.1 Bed Replacement --------------------------------------------------------------------------------------------------------5-18
Removing Aluminum Bed ----------------------------------------------------------------------------------------------5-18
Installing Aluminum Bed ------------------------------------------------------------------------------------------------5-18
4.2 Filter Replacement -------------------------------------------------------------------------------------------------------5-18
4.3 Cartridge Replacement -------------------------------------------------------------------------------------------------5-22
4.4 Nozzle Replacement ----------------------------------------------------------------------------------------------------5-22
Methods of Detaching Nozzle -----------------------------------------------------------------------------------------5-22
Assembling the Nozzle -------------------------------------------------------------------------------------------------5-24
Chapter 6 Appendix
1. Type of Consumables (Material, Color) ------------------------------------------------------------------------- 6-2
ⅲ
To Next Page
Loading...
